Study-Unit Description

Study-Unit Description


CODE ENR5020

 
TITLE Dissertation

 
LEVEL 05 - Postgraduate Modular Diploma or Degree Course

 
ECTS CREDITS 80

 
DEPARTMENT Faculty of Engineering

 
DESCRIPTION This study-unit requires the student to methodically address a research problem for which the aims and objectives are clearly defined in a research proposal. The student will be assigned a Principal Supervisor who will provide guidance on formulation of the proposal, offer support and ideas during the course of the student's work, provide advice and monitor progress as set out in the University's General Postgraduate Regulations.
The type of work produced, design, experiments, simulation, analysis and methodology will depend on the nature of the research and constitute a defined subset within the area of study under investigation. By the end of the prescribed study period, the student will submit an original dissertation of between 35,000 and 40,000 words on the research performed.

Study-unit Aims

The aims of this study-unit are for the student to perform advanced research according to a pre-defined proposal using the relevant methodologies from engineering. In this manner, the student will apply and develop the required research, analytical and design skills together with the relevant theories that are required to address the task at hand. In addition to the application of such advanced research skills, the student will learn to manage resources, make informed decisions, define a research problem, formulate research proposals, communicate effectively and enhance his/her oral presentation and report-writing skills.

Learning Outcomes

1. Knowledge & Understanding:

By the end of the study-unit the student will be able to:

- Address an engineering research problem in a structured and well-defined manner as demanded by the relevant research methodologies.
- Demonstrate an advanced superior knowledge and provide explanations on the specific problem domain captured by the research activity.
- Deliver learned contributions to the area under study.

2. Skills (including transferable [generic] skills):

By the end of the study-unit the student will be able to:

- Describe the scientific work performed in a written manner by means of technical reports, publications and a dissertation.
- Deliver oral technical presentations on the work performed.
- Critically review, analyze and discuss research papers.
- Apply research methodologies to analyze and design engineering systems.

Main Text/s and any supplementary readings

Depends on the title of research

 
ADDITIONAL NOTES **Resit Availability: Students who fail to obtain an overall pass mark will be re-examined in the Dissertation. However, the resit availability for the Oral Examination is at the discretion of the Board of Examiners.

 
STUDY-UNIT TYPE Dissertation

 
METHOD OF ASSESSMENT
Assessment Component/s Assessment Due Resit Availability Weighting
Dissertation and Oral Examination (See Add. Notes) See note below ** 100%
Note: Assessment due will vary according to the study-unit availability.

 
LECTURER/S

 
The University makes every effort to ensure that the published Courses Plans, Programmes of Study and Study-Unit information are complete and up-to-date at the time of publication. The University reserves the right to make changes in case errors are detected after publication.
The availability of optional units may be subject to timetabling constraints.
Units not attracting a sufficient number of registrations may be withdrawn without notice.
It should be noted that all the information in the description above applies to study-units available during the academic year 2020/1. It may be subject to change in subsequent years.

https://www.um.edu.mt/course/studyunit